欧美黑人3p-欧美黑大硬粗免费视频-欧美黑大粗-欧美黑粗特黄午夜大片-欧美黑白配性xxxxx-欧美黑b

Here, let me show you how:

For those of you unable to watch the above (reading shamefully in the office or while balancing your phone on your knee in the bathroom), first let me tell you that you are really missing out, since in the video, I give you some extra tips to make things easier–but anyway, let me break the process down pretty simply:

First, take your wheel off. You’re going to want to do that by loosening your lug nuts first, then jacking up your car, then taking the nuts and wheel off.

Pro tip: You might also want to tuck in your shirt there, genius

Second, take off the brake caliper and pad bracket. For the uninitiated, this is the large, ugly metal thing that wraps around the circular brake rotor.

It’s the rusty-looking thing on the left, there

You will need a socket wrench set, and most likely a short length of pipe to slide over the handle to give you the leverage you need, usually called a “breaker bar” (because it “breaks” the static friction holding the bolt in place). The caliper is most likely held on by bolts on the interior side. After you take it off, though, don’t drop it or let it hang from that hose, or you will be facing the double problem of brake fluid everywhere and suddenly needing to fix the damage to your brake line.

Third, take off the old rotor and put the new one on. A few places say to hit the old one with a hammer or rubber-headed mallet to remove it, but mine came off fairly easily by just pulling.

Finally, reverse the steps. Put the caliper and bracket back on (if it won’t fit back on, then you will most likely need to take a great big wrench or a c-clamp to squeeze back in the piston itself, which is the multi-tiered hydraulic press-looking thing behind the brake pads—it will be a little difficult to do), then replace the wheel and lug nuts (although don’t tighten all the way until you put it back on the ground).

IMPORTANT NOTE HERE: If you did need to push back in the brake piston, the first time you step on the brakes, it will not work. Before you move, step on the brakes a few times to get the piston extended the correct amount.

Congratulations! You just replaced your own brake rotor, a feat that, to the uninitiated, sounds fairly impressive along with a sigh, cracking open a beverage of your choosing, and a “Welp, my rotors are warped, so I had to throw the car up on jacks, unbolt the calipers, and just get in there, you know?”

Also, the dirt can back up your ‘do it myself’ strong image

Feel free to quote me on that one.